stress distribution

Because the main arch and the center line of the bridge in the horizontal projection is misaligned, the deformation and stress distribution of the bridge are very complex.

主拱肋轴线水平面内的投影与桥梁中心线的不重合，全桥的变形和受力情况都很复杂。

Objective : To study stress distribution in periodontal tissue of titled abutment before and after fixed restoration.

目的: 研究倾斜基牙固定修复前后牙周组织受力情况,为临床固定义齿设计提供理论依据.

The width and depth of laser transformation hardening zone and residual stress distribution were measured experimentally.

实测了激光相变硬化区的宽度和深度及残余应力分布.

According to the regulation of axial stress distribution, a way to design the rational end construction is given.

根据端部所呈现的应力分布规律，提出了确定端部合理结构型式的方法。

We defined the conditions of the plane stress distribution of thin plates subjected to in-plane forces.

我们定义了承受平面力的薄板平面应力分布条件.

This paper summarizes the modes of axial stress distribution of bolt and analyses their mechanism.

本文系统总结了锚杆轴力分布型式，分析了各轴力分布型式的力学机理。

Curve fitting method of bond stress distribution in steel bar pullout test

钢筋拉拔试验中粘结应力分布的曲线拟合

And ome advice is proposed to improve the design. The stress distribution of the amendatory anchor span achieves design criterion.

根据分析得到的结果对锚固跨的设计提供了改进的意见，修改设计方案后，锚固跨在各阶段的应力分布均满足了设计要求。

The results indicated that smaller bond area will not make the stress distribution more rational.

结果表明：减小模型粘结面积不会对模型的应力分布模式有明显的优化作用。

The axial stress distribution after cooling is changed greatly under internal pressure.

介质压力对完全冷却后的轴向应力产生较大影响.

The stress distribution and amount of deformation has been counted under different pavage conditions.

计算不同情况下该种管道的应力分布及变形量.

Under the same loads, the improved swinging arm had a better stress distribution.

改进后在同样的载荷下, 摆臂的应力分布更加合理.

From this way, the design of lamp module of KFTA solar simulator is introduced, and the stress distribution of xenon short arc lamp is analyzed.

文章正是从以上各个方面阐述了KFTA太阳模拟器灯单元的设计思想及方法。

Quantitative analysis for the stress distribution has proved the feasibility of micro-grid application in industrial furnace.

对微格栅砌体应力分布的定量分析表明:微格栅砌体完全能够满足工业炉炉体的力学性能要求.

Preliminary Analysis for the Space Distribution of Present Stress Field in Jiangsu and its Adjacent Area

江苏及邻区现代应力场空间分布特征分析

Throuth the stress calculation for the model slices the pipes D stress distribution state is solved.

通过对冻结模型的切片应力计算,求出了涵管在静土压力下的三维应力分布.

Numerical Analysis of Stress Distribution of Adhesively Bonded Metal Joint under Cleavage Loading

劈裂载荷作用下金属胶接接头中应力分布的数值分析

Stress distribution on the surface of alveolar bone is very complex, not simple compression or tension.

齿槽骨表面的应力分布非常复杂,同一部位三个主应力值相差很大,且多为反号, 不是简单的受拉或受压.

Steady Temperature Distribution and Thermal Stress Analysis for Double Hull Structure

双壳型船体结构稳态温度场和温度应力

A general solution for stress distribution around rectangle holes in anisotropic elastic plates is presented.

推导了各向异性平面弹性体中矩形孔洞边缘的应力分布公式并给出了数值计算结果.

This paper chiefly describes the general character of stress distribution of the arch shaped arch-abdomen dam.

本文着重介绍拱形腹拱坝的坝体应力的一般规律.

Numerical Analysis of Dynamic Response and Axial Stress Distribution of Rock Bolts Under Explosive Loads

锚杆动载响应和轴向应力分布规律数值分析

A method for calculating the temperature distribution, thermal stress and low-cycle fatigue of drum walls with a two dimensional transient temperature field is presented, together with a computer program for calculating the low-cycle fatigue life of boiler drums.

提出了非稳态二维温度分布下汽包壁温度和应力分析及疲劳寿命计算方法，并编制了相应的计算机程序。

By analyzing the stress distribution of anchor span at construction stage and working stage, the paper draws some valuable conclusions.

通过对锚固跨在施工阶段和正常运营阶段应力分布的系统研究，得出一些有价值的结论。

Results: The deviation and stress distribution of the edentulous jaws and the base plates were obtained.

结果: 得出了七种模型的基托及无牙颌骨的位移及应力分布值.

The stress distribution of cable-girder anchorage zones under cable forces and U-prestressing tendon is analyzed.

分析了索力和U形钢束共同作用下主梁锚固区应力大小及分布情况.

Temperature Distribution, Thermal stress Analysis and Low-cycle Fatigue in Boiler Drum Walls of Pecking Units

调峰机组锅炉汽包壁温度场和热应力分析及低周疲劳设计

Finite Elements Numerical Solution of the Thermal Stress Distribution in Ice Cover

冰层热应力非线性有限元分析

Using method of three dimensional FEM analysis, whole stress distribution in the joints is are obtained.

用三维弹塑性有限元分析方法, 全面分析了点焊搭接接头的应力分布情况.

Three-dimensional modal, stress distribution and harmonic response laws of water-lubricated bearings were studied using element software.

利用有限元软件研究了水润滑轴承的三维模态及其应力分布和谐响应规律.